User's Guide

This manual describes the

TRL209 SINGLE BOARD COMPUTER

for Pentium, 6x86 and compatible Applications

TRL209 Pentium Single Board Computer User's Guide

August 1996

Copyright TriEMS Research Lab, Inc. 1996

All rights reserved

TriEMS Research Lab, Inc.

1275 N. Tustin Ave

Anaheim, CA 92807

(714) 575-1122 Phone

(714) 575-9272 FAX

The following Trademarks are used in this document:

TriEMS is a trademark of TriEMS Research Lab, Inc.

IBM PC, XT, AT, CGA, EGA, VGA and OS/2 are registered trademarks of International Business Machines Corp.

Intel and Pentium are registered trademarks of Intel Corp.

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.

VIA is a registered trademark of VIA, Inc.

UNIX is a registered trademark of American Telephone and Telegraph.

XENIX is a registered trademark of Santa Cruz Operation, Inc.

AMI and WINBIOS are trademarks of American Megatrends, Inc.

Cyrix is a registered trademarks of Cyrix Corp.

TI is a registered trademark of Texas Instruments Inc.

VESA and VL-Bus are trademarks of Video Electronics Standards Association.

PCI is a registered trademarks of Intel Corp.

SMC is a registered trademark of Stanfard Microsystems Corporation.

TriEMS Research Lab, Inc. assumes no responsibility for errors in this document, and retains the right to make changes at any time, without notice. Please call TriEMS Technical Support at (714) 992-4303 if you have any questions.

Printed in the United States of America

968 7 6 5 4 3 2 1

Part Number DOC-TRIEMS200209-A1.00 COPYRIGHT

This product, including software and documentation, may not, in whole or in part, be copied, photocopied, translated or reduced to any electronic or machine-readable form without prior written consent from the vendor, except for copies retained by the purchaser for backup purposes.

No warranty or representation, either expressed or implied, is made with respect to this documentation, its quality, performance, merchant ability, or fitness for a particular purpose. As a result, the documentation is licensed "as is", and the licensee will assume the entire risk as to its quality and performance. This manual and any accompanying software and documentation, if any, are copyrighted by TriEMS and all rights are reserved. The vendor reserves the right to revise this operation manual and all accompanying software and documentation and to make changes in the content without obligation to notify any person or organization of the revision or change.

In no event will the vendor be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use this product or documentation even if advised of the possibility of such damages, in particular, the vendor shall not have liability for any hardware, software, or data stored or used with the product, including the costs of repairing, replacing, or recovering such hardware, software or data.

COPYRIGHT c 1996 TriEMS Research Lab, Inc.

Class A Computer Device

This equipment has been tested and found to comply with limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a industrial and commercial installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Re-orient or relocate the receiving antennas.

2.Increase the separation between the equipment and the receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio/TV technician for help.

NOTE:

Use of shielded power and interface cables with this equipment is required in order to ensure compliance with FCC specifications.

CAUTION:

Changes or modifications to this equipment not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.